Customizable LOAD SIMULATOR test system subrack
THE LOAD SIMULATOR SUBSYSTEM IS COMPOSED BY DIFFERENT DRAWERS WHICH SIMULATE VARIOUS AND CUSTOM LOAD LINES (PYRO, NEA, LV, BSV, MSV AND LCL).
-
What it's for
The system allows to switch the power lines from the fixed load to “Power sense module” that is composed by an electronic load (with internal short circuit generator) and a sensing system for the current and voltage measure.
The connections with the oscilloscope (not present in this rack) allows the complete static and dynamic verification of any power lines (current limitation, trip-off time, dynamic pulsed response and short circuit).
The system will be composed also by another modular drawer (3U) with Nr.6 electronic loads (50W max each), every module will have front bushings to facilitate the manual connection with the bushings of fixed loads.
The switch board cabinet through its component will manage the voltage and current measures for each load line under test.
-
Main Characteristics
- Front panel with status led and Banana socket
- Two for current measure
- One for Return or positive connection for additional loads
- 3 dissipator with fan where are placed Resistor and thermistor
- Rear panel with DB 50 connector to connect load to switch boards
- Double fuse for each line for LCL and NEA
- Single fuse for heater groups plus single fuse for each Heater lines
- GND-CHASSIS Banana socket for chassis connection
- AC line input for FAN power supply
- Local or remote static load switching (On/Off/Short circuit)
- Individual front panel test points
- Mains isolation transformer unit
- Mini rack
- Auto-test features
- Re-usable container
- Front panel with status led and Banana socket
Key features:
- Thermorelays (50deg) for fan activation
- Static load power-on status (local or remote)
- Specific sensor simulation (thermistor, cell sample, switch, etc.)
- Remote control via TCP/IP interface
- Interface harness (ambient, vacuum, bio-burden cables, bulk head to vacuum chamber, savers etc.)
